Plasma Cutter 40Amp Dual Voltage 110/220V Cutting Machine

Description

Short Description
1. Voltage: 110/220V,
1-PH, 50/
60HZ
2. Current rage:20-
40
A
3. Duty cycle:
30
%
@ 40
℃
(104
℉
)
4. Max cutting thickness: 12mm
5. D
esigned for cutting stainless steel, alloy steel, mild steel, copper aluminum, and other
metal materials
Description
JAYFL CUT40 is an IGBT type air plasma cutter with high frequency start.
It is designed for cutting stainless steel, alloy steel, mild steel, copper aluminum, and other metal materials; there are many applications of plasma cutters.
JAYFL CUT40 has characteristics as following:
● Stabilization
● Power efficiency and low noise output
● Reliability
● High cutting speed
● Portability
● Smooth cuts
WHAT'S INCLUDED
Power Supply
Power Cutting Torch
Plasma Cutting Consumables
Ground Clamp
Air Filter & Regulator
Air Hose
Air hose Connections
CUTTING
For straight edge cutting, the torch should
be held at a
90°
angle to the plate and
dragged along the job. The cutting speed
will depend on the material thickness,
amperage and airflow rate.
In general a good cutting speed will result
in the shower of sparks at an angle of 15
to 20 degrees from the cut.
PIERCING
To pierce material, the cutting torch tip
should in contact with the job but held at
an angle of 45°to the surface. Then the
torch is moved to the 90° position.
Piercing thickness is dependent on the
output of the machine and is generally
50% of the rated cutting thickness of
the power source.
It is important to direct the arc away from
the operator when establishing the arc as
sparks and molten material will be ejected
from the point of contact. Care must also
be taken to protect the surrounds from
these sparks.
Technical Details
General Specification
Input Voltage
110 - 220V, 1-PH, 50/60Hz
Input Current
110V @ 40A
220V @ 20A
Duty Cycle
30% @ 40A @ 40
℃
(104
℉
)
Ambient Temperature
-10 - 40℃ / 14 - 104℉
Dimension(inch/mm)
14.6 x 5.9 x 11.8
370 x 150 x 300
Weight
17.2 lbs / 7.9kg
Plasma Cutting Specification
Output Current
10 - 40A
Output Volta
230V
Material
Stainless steel, mild steel, aluminum ,etc.
Gas supply
Clean, dry, oil-free air
Recommended Pressure
0.6 - 0.75Mpa
Flow Rate
3.0 scfm @70Psi
Max Cutting Thickness
12mm
Additional Information